1、He's a crank, and a noxious crank.
2、geared inclinable crank press
3、crank shaft impulse neutralizer
4、slider crank chain
5、open crank case compressor
6、Screw, crank cover
7、digital display crank shaft grinder
8、back-side-crank pumping unit
9、steering clutch release crank axle
10、Engine crank tachometer provide VTEC control function.
11、open-type double action crank press
12、 He started to crank the engine.
13、He is a fresh air crank.
14、He's a crank, and a noxious crank. He calls himself an idealist.
15、The propeller will windmill and crank the engine.
16、The pedal of a cycle is attached to a crank.
17、A shaft that turns or is turned by a crank.
18、Just crank up your hearing aid a peg or two.
19、And then starting to turn the crank on the algebra.
20、Compared with conventional beam pumping unit, the swing-rod beam pumping unit can reduce the maximum crank axle torque markedly, reduce and even eliminate negative crank axle torque.
21、The bell crank is attached to the universal joint, left and right tie rods, and to the trike frame. The bell crank assembly is shown below.
22、This paper expounded and proved some special geometric relations of the planar crank-rocker mechanisms, gave a new graphic method for designing the planar crank-rocker mechanisms.
23、If you can't "turn the build crank" frequently enough, both development and testing suffer.
24、A simulation of crank-guide-bar-slider mechanism based on MATLAB and Pro/E
25、Then, someone comes by and shows you how to crank the chainsaw.
26、The Delorean factory was supposed to crank out 30,000 of these futuristic looking cars.
27、Compulsion means the dog offers the behavior to avoid a correction (yank and crank training).
28、To start the engine, one must first light the small flame beneath the hot ignition tube and crank the engine once using the crank; these preparations take only a minute.
29、Rotate the crank handle of bed board c, patient can be moved parallelly to another ward bed or operation table.
30、The procedures are chamfering both sides of the gudgeon pin and crank pin core and semi-finishing the crank pin bore at a rate of 1000 pieces per hour at 100% efficiency.
